Husqvarna Mondo Whipper Snipper Used Parts
All parts listed below are in good used condition.
To enquire about any of these, please contact us.
Rear Cowling / Crankcase Back
Also includes rear cover and mounting screws.
1 in stock
Throttle Control Assembly
Includes hand grip, lever, cable, on/off switch and wiring harness and cable fixing screw. 1 in stock
Clutch Assembly
Includes complete clutch bell assembly, metal clutch shoe assembly with spring, washers, nut and spacing tube. 1 in stock
Bump Feed Cutter Head
Complete cutter head including spool, spool cover, bump knob, return spring and lock nut.
NO LONGER AVAILABLE HUSQ4
Handle & Cutter Guard / Shield
Includes wing nuts and built-in trimmer line striker knife. 1 in stock
Starter Assembly
Complete starter assembly ready to install. Comes with mounting screws and flywheel assembly - with plastic starter pawls installed. 1 in stock
Air Filter Assembly
Comes complete with intake block, air cleaner element, air cleaner holder bodies, primer bulb, screws, choke lever and position plate. 1 in stock
Fuel Tank / Petrol Tank
Comes with fuel cap and rubber tank grommets.
NO LONGER AVAILABLE HUSQ8
Muffler / Exhaust
Comes with two holding springs. 1 in stock
Ignition Coil Assembly
Comes complete with spacer, mounting screws & wiring harness. 1 in stock
Drive Shaft / Lay Shaft
Flexible inner drive shaft. Measures 1307mm long.
NO LONGER AVAILABLE HUSQ11
|